Wika T53 Manual do Utilizador descarregar pdf (Página 15)

2.6.7 Measurement of resistance (linear) with two sensors:

PRIMARY_VALUE_UNIT . . . . = Ohm or kOhm

LIN_TYPE. . . . . . . . . . . . . . . . = No linearisation

LIN_TYPE_2

. . . . . . . . . . . . . . = No linearisation

SENSOR_MEAS_TYPE . . . . . = Anything, but not "PV = SV_1, SV_2 not available"

SENSOR_CONNECTION . . . . = 2- or 3-wire

SENSOR_CONNECTION_2

. . = Default set to 2-wire

RJ_TYPE . . . . . . . . . . . . . . . . = N/A (ignored in setup check)

Connections:

2.6.8 Measurement of potentiometer (linear) with one sensor:

PRIMARY_VALUE_UNIT . . . . = %

LIN_TYPE. . . . . . . . . . . . . . . . = No linearisation

LIN_TYPE_2

. . . . . . . . . . . . . . = N/A (ignored in setup check)

SENSOR_MEAS_TYPE . . . . . = PV = SV_1, SV_2 not available

SENSOR_CONNECTION . . . . = 3- or 4-wire

SENSOR_CONNECTION_2

. . = N/A (ignored in setup check)

RJ_TYPE . . . . . . . . . . . . . . . . = N/A (ignored in setup check)

Connections:

2.6.9 Measurement of potentiometer (linear) with two sensors:

PRIMARY_VALUE_UNIT . . . . = %

LIN_TYPE. . . . . . . . . . . . . . . . = No linearisation

LIN_TYPE_2

. . . . . . . . . . . . . . = No linearisation

SENSOR_MEAS_TYPE . . . . . = Anything, but not "PV = SV_1, SV_2 not available"

SENSOR_CONNECTION . . . . = Default set to 3-wire

SENSOR_CONNECTION_2

. . = Default set to 3-wire

RJ_TYPE . . . . . . . . . . . . . . . . = N/A (ignored in setup check)

Connections:

Connections with two sensors

can be configured for

2 measurements, difference,

average or redundancy

Connections with two sensors

can be configured for

2 measurements, difference,

average or redundancy

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 36 37

Sem comentários

Wika T53 Manual do Utilizador Página 15