Wika CPH6300 Manual do Utilizador descarregar pdf (Página 13)

6 Commissioning, Operation

WIKA Operating Instruction, Model CPH6300 13

14043054.01 07/2012 GB/D

6.2 Operating

Connect sensors, turn device on via key.

After segment test the device displays some configuration:

if standard measurement is selected

if fast measurement is selected

if peak value detection is selected

After that the device is ready for measuring.

6.3 Configuration

Some menu points depend on current device settings (e.g. some menu points are

locked, if the logger memory contains data sets).

To change device settings, press “MENU” for 2 seconds. This will activate the configuration

menu (main display: “SEt”). Pressing “MENU” changes between the menus points, pressing

jumps to the referring parameters. The parameters can be changed with or . (Switch

through the parameters with .)

Pressing “MENU” again jumps back to the main configuration menu and saves the settings.

“STORE” finishes the configuration and returns to standard measuring operation.

Pressing “MENU” and “STORE” at the same time for more than 2 seconds will reset

the device to factory defaults.

If there are data sets stored and logger is set to “manual recording” (“Func Stor”) the

first menu point displayed is “rEAd Logg” (see chapter 6.5 “Data Logger”)

If no key is pressed for more than 2 minutes the configuration will be aborted. All

changes will not be saved!

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Sem comentários

Wika CPH6300 Manual do Utilizador Página 13