Wika TGT70 Manual do Utilizador descarregar pdf (Página 10)

14047194.02 02/2013 GB/D/F/E

10 WIKA operating instructions model TGT70

The built-in Bourdon tube system generates a rotational pointer movement that is

proportional to the temperature. An electronic angle encoder (non-contact, and therefore

completely free from wear and friction) determines the position of the instrument pointer.

From this, the electrical output signal is produced, proportional to the temperature.

4.2 Scope of delivery

Cross-check scope of delivery with delivery note.

5. Transport, packaging and storage

5.1 Transport

Check the instrument for any damage that may have been caused by transport.

Obvious damage must be reported immediately.

5.2 Packaging

Do not remove packaging until just before mounting.

Keep the packaging as it will provide optimum protection during transport (e.g. change in

installation site, sending for repair).

5.3 Storage

Permissible conditions at the place of storage:

Storage temperature: 0 ... 40 °C

Avoid exposure to the following factors:

■

Direct sunlight or proximity to hot objects

■

Mechanical vibration, mechanical shock (putting it down hard)

■

Soot, vapour, dust and corrosive gases

■

Potentially explosive environments, ammable atmospheres

Store the instrument in its original packaging in a location that fulls the conditions listed

above. If the original packaging is not available, pack and store the instrument as described

below:

1. Wrap the instrument in an antistatic plastic lm.

2. Place the instrument, along with shock-absorbent material, in the packaging.

3. If stored for a prolonged period of time (more than 30 days), place a bag containing a

desiccant inside the packaging.

4. Design and function / 5. Transport, packaging and storage

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

Sem comentários

Wika TGT70 Manual do Utilizador Página 10