Wika CPG2500 Manual do Utilizador descarregar pdf (Página 55)

Mensor/WIKA Operating Instructions Series CPG 2500 55

Digital Pressure Gauge

SERIES CPG 2500

The ‘Q’ Command Data/Output Format

n Description Output Format

0 Pressure reading in the se-

lected units. This is the default

output format.

NNNNNNN<cr><lf>where each N is a number (0

through 9), +,-,decimal point, or a space. If the pres-

sure rate or peak monitor option is being used the

output format is NNNNNNN,NNNNNNN<cr><lf>. The

data before the comma is the pressure and the data

after the comma is the pressure rate or peak.

1 Raw A/D readings (for factory

use)

nnnnnnn,nnnnnnn<cr><lf> where each n is a number

(0 through 9) or a space.

2 Unit ID Unit ID for the CPG 2500

3 Pressure range and measure-

ment units

NNNNNNN,NNNNNNN, @@@@@@@<cr><lf> where

each N is a number (0 through 9), decimal point, or a

space and each @ is an alpha-numeric character. The

output string represents the minimum pressure, maxi-

mum pressure and the pressure units.

4 Error status code CPG 2500’s error codes

5 Calibration data not emulated

6 Pressure rate or peak indica-

tion

nnnn where each n is a number (0 through 9) valid only

if optional pressure rate or peak is enabled. The mean-

ing of each digit is shown under the related feature in

the Options section of the DPG II manual.

7 Zero and span corrections ZZZZZZZ,SSSSSSS<cr><lf> where ZZZZZZZ is the

zero correction and SSSSSSS is the span correction.

8 Calibration coefficients not emulated

S Command: same as SPAN command.

T Command: used with RATE option; similar to DISPLAY command.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 87 88

Sem comentários

Wika CPG2500 Manual do Utilizador Página 55