Wika BCS10 Manual do Utilizador descarregar pdf (Página 14)

WIKA operating instructions calibration system, model BCS10

14051046.01 10/2012 GB/D/F/E

6. Commissioning, operation

Commissioning may only be carried out by trained and qualied personnel. The calibra-

tion system was comprehensively checked ex works for tightness.

WARNING!

Only connect or disconnect test and calibration installations once the

system has been depressurised!

6.1 Switching on and o

To switch on the calibration system,

press the Power key (1). Press the

Power key again to switch o the

calibration system.

After switching on the version of the

rmware is indicated on the display for

approx. 1 second.

6.2 Zero point adjustment

To set the displayed value as zero

point, simply press the ZERO key (3).

The display changes immediately to the

0 value.

6.3 MIN/MAX value

The digital pressure gauge saves the

minimum and maximum pressure.

If the MAX/MIN key (4) is pressed once,

the maximum pressure from the memory is displayed. If the MAX/MIN key is pressed

again, the minimum pressure is displayed from the memory.

After 2 seconds, the display switches back to the operating mode. To clear the MAX/MIN

memory, press the MAX/MIN key (4) for at least 2 seconds until the message "CLr" is

displayed.

The bargraph display at the bottom of the display indicates the applied pressure relative

to the total measuring range.

Due to a possible Tare setting, the displayed pressure value can dier

from the applied pressure.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 107 108

Sem comentários

Wika BCS10 Manual do Utilizador Página 14